VA0-32SVH

Cut-away view of the VA0-32SV tanning bed

This SUNVISION Elite® 32 was shipped with the following lamps:
Velocity® Select Wolff® Model VS 71-T12-100W Bi-Pin

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 47

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10894|Trim Profile, Gray (Full Length)

Full-length gray colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

10903|Cover, Bench Grey (Power Near Head-end)

Bench cover for SunStar® and Sunvision Elite™ commercial tanning beds
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

21089|Timer Keypad Pushbuttons, NF (On bracket)

Membrane keypad assembly. This is only the adhesive backed membrane keypad affixed to the head-end canopy endcap of the tanning bed, not the timer display circuit board.
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]

21733|Gas Spring Set, 1500N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

21916|Bushing, Sintered Iron 10mm

Sintered iron bushing that is inserted into the canopy mounting arm where the gas spring connects. Replaces Bronze Bushing.
[Product Details...]

22591|Acrylic, Canopy (Sunvision Elite™)

Canopy acrylic for Sunvision Elite™ commercial tanning beds and older SunStar® ZX-models (G2 to present)
[Product Details...]

22780|Endcap Insert, Center (no timer)

Center insert for ZX32 endcap when timer keypad is not used
[Product Details...]

22783|Endcap Insert, Center (with timer cut-outs)

Center insert for ZX32 endcap that contains the timer keypad (not included)
[Product Details...]