S-48VIP

View of the Solar System 48 VIP tanning booth
Cutaway view of the Solar System 48 VIP tanning booth

This Solar System 48 VIP was shipped with the following lamps:
Velocity® VS-R™ Wolff® Model VEL75-T12-160W VS-R Bi-Pin

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 43

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

20989|Capacitor, 75µF (w/ screw stud)

75µF capacitor with screw stud for mounting. Used for power factor correction.
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]

21651|Speaker Terminals

Red and black spring-type speaker terminal assembly
[Product Details...]

23442-01|Grill, Booth

Grill that protects the tanning lamps in the SunDome® tanning booth (all 8 Grills are the same)
[Product Details...]

23443-01|Air Dam

Air Dam (This is a piece of foam attached to the inside of the cover panels that is used to route air flow)
[Product Details...]

23451-01|Joint Plate

Connector plate between modules on top of the SunDome® tanning booth
[Product Details...]

23468-01|Handle, Outside (Orange)

Long handle on the outside of the doors on the SunDome® tanning booth
[Product Details...]

23470-01|Hinge Bushing

Bronze bushing for smooth door operation on the SunDome® tanning booth
[Product Details...]

23471-01|Hinge Locking Pin

Locking pin to keep the doors from lifting off of the SunDome® tanning booth
[Product Details...]

23474-01|Handle, Inside Door

Small black handle on the inside of the doors of the SunDome® tanning booth
[Product Details...]

23481-02|Magnet Strike Plate (Long)

Bent metal plate that contacts the magnet in the doors of the SunDome® tanning booth
[Product Details...]

23568-01|Profile, Trim Center

Plastic trim profile that covers the space between modules on the SunDome® tanning booth
[Product Details...]

23569-01|Profile, Trim Edge

Plastic trim profile that covers the module ends on the SunDome® tanning booth
[Product Details...]

23570-01|Fan, 6" Round (220VAC, 220 cfm)

Round 6" fan used for general cooling of tanning bed.
[Product Details...]

23587-01|Shim Washer

Slip a washer or two under the hinge pin on the SunDome booth to level the doors if necessary
[Product Details...]