N-ZX32H

Cut-away view of the N-ZX32/160 tanning bed
Tanning bed ballast tray open showing internal parts

This SUNSTAR® 332 was shipped with the following lamps:
Velocity® Wolff® Model VEL71-T12/100W PREHEAT-BIPIN (Bench lamps)
Velocity® PLUS Wolff® Model VLP71-T12-100W Bi-Pin (Canopy lamps)

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 4 Next >> End >> >>

Results 1-20 of 68

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10072|Contactor (240VAC, 40A)

Tanning bed control contactor rated for 40 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20592|Relay (220VAC, 15A)

15A contact relay, usually used to activate cooling fans in tanning beds
[Product Details...]

20802|Gas Spring Set, 1200N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

20941|Access Panel Key

Key for the front access panel of the tanning bed.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

20989|Capacitor, 75µF (w/ screw stud)

75µF capacitor with screw stud for mounting. Used for power factor correction.
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]

21916|Bushing, Sintered Iron 10mm

Sintered iron bushing that is inserted into the canopy mounting arm where the gas spring connects. Replaces Bronze Bushing.
[Product Details...]

22153|Acrylic Protector strip (For Support Rail)

Clear protective strip that clips onto the aluminum support rails to keep the rails from scratching the tanning bed acrylics
[Product Details...]

22828|Caster, Tray Roller

Wheel assembly on the bottom of the commercial tanning bed ballast trays
[Product Details...]

22829|Handle, Tray Pull

Black plastic handle on top of ballast tray in commercial tanning beds
[Product Details...]

22847|Filter, 10" x 24" x 1"

Furnace-type air filter to keep dust out of commercial tanning beds
[Product Details...]

22880|Capacitor, 1µF

Capacitor on Terminal block to keep fans from seizing
[Product Details...]

23102-01|Pillow, Grey Vinyl

Block shaped foam pillow with vinyl covering for commercial tanning beds
[Product Details...]