M-ZX32H

Cut-away view of the T-332 tanning bed
Tanning bed ballast tray open showing internal parts

This SUNSTAR® ZX32 SPEED®system was shipped with the following lamps:
SPEED® 175 Wolff® Model SPD75-T12 PREHEAT BIPIN (Bench lamps)
SPEED® 205 Wolff® Model SPD71-T12-205 Bi-Pin (Canopy lamps)

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 50

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20592|Relay (220VAC, 15A)

15A contact relay, usually used to activate cooling fans in tanning beds
[Product Details...]

20802|Gas Spring Set, 1200N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

20941|Access Panel Key

Key for the front access panel of the tanning bed.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

20989|Capacitor, 75µF (w/ screw stud)

75µF capacitor with screw stud for mounting. Used for power factor correction.
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]

21916|Bushing, Sintered Iron 10mm

Sintered iron bushing that is inserted into the canopy mounting arm where the gas spring connects. Replaces Bronze Bushing.
[Product Details...]

22153|Acrylic Protector strip (For Support Rail)

Clear protective strip that clips onto the aluminum support rails to keep the rails from scratching the tanning bed acrylics
[Product Details...]

22847|Filter, 10" x 24" x 1"

Furnace-type air filter to keep dust out of commercial tanning beds
[Product Details...]

22880|Capacitor, 1µF

Capacitor on Terminal block to keep fans from seizing
[Product Details...]

23102-01|Pillow, Grey Vinyl

Block shaped foam pillow with vinyl covering for commercial tanning beds
[Product Details...]

23120-05|Wiring Harness, Remote PCB to Timer (7")

Wiring harness that runs from the timer in the ballast tray of commercial tanning beds to the remote connection PCB on the tray lid (7" long)
[Product Details...]

23187-01|Remote Connection PCB

Small circuit board with two RJ-22 connections for tanning bed remote operation
[Product Details...]

24176-01|Timer Display PCB, ADI-HT

Circuit board with LED display behind pushbutton membrane keypad, inside head-end endcap in tanning bed canopy
[Product Details...]