M-26RSH

Cutaway view of the SunQuest 26RS tanning bed

This SunQuest® 26RS was shipped with the following lamps:
GT Wolff® Model GT171-T12-100W BI-PIN

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 Next >> End >> >>

Results 1-20 of 32

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10152|Cover, Bench 7' (2-fan)

White, 7' home tanning bed bench cover with 2 fan holes
[Product Details...]

10225|Cover, Canopy 7' (1-fan)

White, 7' light commercial tanning bed and home tanning bed canopy cover with 1 fan hole
[Product Details...]

10713|Trim Profile, 7' Blue

Blue colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

16417|Timer Bezel, 20 minute (with cool-down and Control Key)

Gray plastic bezel with marks for a 20 minute eletro-mechanical timer. Includes Cool Down and hole for Control Key switch.
[Product Details...]

16901|Profile, 6' Blank

White plastic profile that secures the acrylic on a 7' tanning bed.
[Product Details...]

20003|Pillow, Grey Foam

Grey foam pillow for tanning beds
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20146-02|Starter, K-11

Starter for Fluorescent tanning lamps, K-11
[Product Details...]

20288|Leg Kit (White)

Kit contains 2 stand legs for light commercial tanning beds and home tanning beds
[Product Details...]

20291|Hardware Kit, Assembly Hardware

Kit includes only the screws and bolts required to assemble SunQuest® and Sunvision® tanning beds
[Product Details...]

20741|Timer (220VAC, 60Hz, 20min. w/ cool-down)

Electro-mechanical timer with 20 minute duration and 3 minute cool-down cycle. For use in 220V home tanning beds.
[Product Details...]

21893|Hinge Brackets, Left & Right Kit

Kit includes both plastic hinges for Sunvision® light commercial tanning beds and SunQuest® home tanning beds
[Product Details...]

22116|Gas Spring Set, 425N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

22356|Leg Mount Internal

These are the brackets the stand legs bolt into inside the tanning bed bench. Kit contains three internal leg mounting brackets to replace one side of the tanning bed.
[Product Details...]