L-ZX30H

Cutaway view of the SunStar ZX30 tanning bed

This SUNSTAR® ZX30 SPEED®system was shipped with the following lamps:
SPEED® 175 Wolff® Model SPD75-T12 PREHEAT BIPIN (Bench)
SPEED® 205 Wolff® Model SPD71-T12-205 BIPIN (Canopy)

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 47

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10894|Trim Profile, Gray (Full Length)

Full-length gray colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

10895|Trim Profile, Canopy Rear Middle (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10896|Trim Profile, Canopy Rear Ends (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10903|Cover, Bench Grey (Power Near Head-end)

Bench cover for SunStar® and Sunvision Elite™ commercial tanning beds
[Product Details...]

10928|Cover, Canopy Blue (no Face Tanner)

Dark blue, contoured canopy cover for SunStar® commercial tanning beds, logo decal included
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20317|Foot Cap

Plastic cap on the bottom of each stand leg of SunStar® commercial tanning beds
[Product Details...]

20941|Access Panel Key

Key for the front access panel of the tanning bed.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

21089|Timer Keypad Pushbuttons, NF (On bracket)

Membrane keypad assembly. This is only the adhesive backed membrane keypad affixed to the head-end canopy endcap of the tanning bed, not the timer display circuit board.
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]

21733|Gas Spring Set, 1500N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

21916|Bushing, Sintered Iron 10mm

Sintered iron bushing that is inserted into the canopy mounting arm where the gas spring connects. Replaces Bronze Bushing.
[Product Details...]

Contraindication: This product is contraindicated for use on persons under the age of 18 years. "Contraindication: This product must not be used if skin lesions or open wounds are present." "Warning: This product should not be used on individuals who have had skin cancer or have a family history of skin cancer." "Warning: Persons repeatedly exposed to UV radiation should be regularly evaluated for skin cancer.

Information about cookies

This site uses cookies. By using the website and its offers and continuing to navigate, you accept these cookies. You can change this in your browser settings. More Information