L-ZX30-3FH

Cutaway view of the SunStar ZX30 3F tanning bed

This SUNSTAR® ZX30 3F SPEED®system was shipped with the following lamps:
SPEED® 175 Wolff® Model SPD75-T12 PREHEAT BIPIN (Bench)
SPEED® 205 Wolff® Model SPD71-T12-205 BIPIN (Canopy)
Heraeus E400 HPT (facial unit)

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 52

Product List

10070|Contactor (240VAC, 30A)

Tanning bed control contactor rated for 30 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10894|Trim Profile, Gray (Full Length)

Full-length gray colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

10895|Trim Profile, Canopy Rear Middle (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10896|Trim Profile, Canopy Rear Ends (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10903|Cover, Bench Grey (Power Near Head-end)

Bench cover for SunStar® and Sunvision Elite™ commercial tanning beds
[Product Details...]

10929|Cover, Canopy Blue (w/ Face Tanner)

Dark blue, contoured canopy cover for SunStar® commercial tanning beds, logo decal included
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20210|Lamp Holder, Face Tanner (HPFT)

Porcelain spring-type lamp holder socket for face tanner lamp. One side only. Two required to hold lamp.
[Product Details...]

20317|Foot Cap

Plastic cap on the bottom of each stand leg of SunStar® commercial tanning beds
[Product Details...]

20455|Thermostat (For Face Tanner)

Small, round thermostat for thermal protection of face tanner cassette in tanning beds
[Product Details...]

20803|Gas Spring Set, 1850N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

20941|Access Panel Key

Key for the front access panel of the tanning bed.
[Product Details...]

20944|Starter, K-12/S-12

Starter for Fluorescent tanning lamps, K-12/S-12
[Product Details...]

20988|Ballast (220VAC, 400W)

Four hundred watt tanning bed choke style lamp ballast. Controls one face tanning lamp.
[Product Details...]