H-ZX30H

Cutaway view of the SunStar ZX30 tanning bed

This SunStar® ZX30 was shipped with the following lamp:
Diamond Sun® S Wolff® Model DSS71-T12-100W PREHEAT BIPIN

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 44

Product List

10072|Contactor (240VAC, 40A)

Tanning bed control contactor rated for 40 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10541|Wiring Harness, Keypad to Timer

This is the wiring harness that runs from the tanning bed timer to the keypad in the head-end endcap.
[Product Details...]

10752|Cover, Canopy

White canopy cover for SunStar® commercial tanning beds, logo decal included
[Product Details...]

10894|Trim Profile, Gray (Full Length)

Full-length gray colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

10895|Trim Profile, Canopy Rear Middle (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10896|Trim Profile, Canopy Rear Ends (Gray)

Gray colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10901|Cover, Bench

White bench cover for the SunStar® ZX30 and 32 series tanning beds
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20146-02|Starter, K-11

Starter for Fluorescent tanning lamps, K-11
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20251|Wiring Harness, Ballast Power Single

Wiring Harness connecting a single electronic ballast to the lamps in the SunQuest® tanning canopy
[Product Details...]

20317|Foot Cap

Plastic cap on the bottom of each stand leg of SunStar® commercial tanning beds
[Product Details...]

20941|Access Panel Key

Key for the front access panel of the tanning bed.
[Product Details...]

21045|Handle, Yellow

Yellow handle on the SunStar® commercial tanning beds
[Product Details...]

21400-02|Remote Control Bypass Plug

The Remote Bypass Plug allows stand-alone operation of your tanning bed when a remote is not needed
[Product Details...]