F-ZX32-3FH

Cutaway view of the SunStar ZX32 3F tanning bed

This SunStar® ZX32-3F was shipped with the following lamps:
Diamond Sun® S Wolff® Model DSS71-T12-100W PREHEAT BIPIN
Philips® Model HPA 400/30s or CosmoTech® Model 23045 or 20046 (facial unit)

Sort by: sort_asc     Display #  
<< << Start << Prev 1 2 3 Next >> End >> >>

Results 1-20 of 52

Product List

10072|Contactor (240VAC, 40A)

Tanning bed control contactor rated for 40 Amps on 240VAC service.
[Product Details...]

10081|Fan, 4" (220VAC, 110cfm)

Square fan, measures approximately 4" on a side, used for general cooling of tanning bed.
[Product Details...]

10541|Wiring Harness, Keypad to Timer

This is the wiring harness that runs from the tanning bed timer to the keypad in the head-end endcap.
[Product Details...]

10562|Silk-Screened Profile (F/G-ZX32-3F)

Plastic side profile with tanning bed logo and warning wording required by FDA.
[Product Details...]

10620|Trim Profile, Yellow

Full-length yellow colored strip that secures the long edges of the tanning bed cover.
[Product Details...]

10621|Trim Profile, Canopy Rear Middle (Yellow)

Yellow colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10622|Trim Profile, Canopy Rear Ends (Yellow)

Yellow colored strip that secures the back edge of the tanning bed canopy cover.
[Product Details...]

10750|Cover, Canopy

White canopy cover for SunStar® commercial tanning beds, logo decal included
[Product Details...]

20063|Capacitor, 75µF

75µF capacitor used for power factor correction
[Product Details...]

20080|Lamp Holder w/o Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Does not have holder for starters.
[Product Details...]

20081|Lamp Holder w/ Starter Holder

Lamp holder for BI-PIN fluorescent tanning lamps. Includes holder for starters.
[Product Details...]

20127|Snap Rivet (for fan grill)

White plastic rivet that holds 4" wire fan grill in place
[Product Details...]

20135|Grill, Fan 4" Wire

4" wire fan grill. Keeps fingers and large debris out of fan blades.
[Product Details...]

20146-02|Starter, K-11

Starter for Fluorescent tanning lamps, K-11
[Product Details...]

20193|Hour Counter

Electro-mechanical hour counter for tanning beds. Keeps track of time the tanning bed is in use.
[Product Details...]

20210|Lamp Holder, Face Tanner (HPFT)

Porcelain spring-type lamp holder socket for face tanner lamp. One side only. Two required to hold lamp.
[Product Details...]

20317|Foot Cap

Plastic cap on the bottom of each stand leg of SunStar® commercial tanning beds
[Product Details...]

20455|Thermostat (For Face Tanner)

Small, round thermostat for thermal protection of face tanner cassette in tanning beds
[Product Details...]

20803|Gas Spring Set, 1850N

Set of gas springs for tanning beds. Set includes 2 gas springs and installation instructions.
[Product Details...]

20988|Ballast (220VAC, 400W)

Four hundred watt tanning bed choke style lamp ballast. Controls one face tanning lamp.
[Product Details...]